Intumescent Paint for Steel

Waterborne single pack intumescent coating/ paint for steel available in Ireland and Northern Ireland.

All our Intumescent coatings Offer 30minute and 60minute fire resistance to steel.

Fully tested and certified to BS476 parts 20/21 for 30minute and 60minute fire resistance to steel.

. Coverage for 30 minute fire protection to steel beams is 3.5m²/litre and to steel columns is 3.0m²/ litre.

For 1 hour fire resistance contact us for individual loadings for our intumescent coatings.

24hour delivery throughtout Ireland and Northern Ireland

more info....


Hamron Steel 2.5 litres Fireproof Paint

Hamron Steel 2.5 litres Fireproof Paint

Hamron Steel 2.5 litres Intumescent Coating for steel. >Suitable for small 30 minute or 60 minute jobs >Waterbased. >Appplication by brush roller or...

£54.00
... more info
Hamron Steel 5 litres Fireproof Paint

Hamron Steel 5 litres Fireproof Paint


£75.00
... more info
Jotun Steelmaster 60WB 18.5litres Fireproof Paint

Jotun Steelmaster 60WB 18.5litres Fireproof Paint

Jotun Steelmaster 60WB 18.5litres Intumescent Coating for Steel. >Suitable for larger 30 minute or 60 minute jobs >Covers 3.5m²/litre for 30 minute...

£140.00
... more info

Intumescent Paint for Steel

Preparation.

Hamron Steel must always be applied to a primed steel substrate. The surface should be dry and free of dust, salts,grease and other contamination immediately before coating. The primer used should be applied in accordance with the specific technical data sheet instructions and must be approved by Hamron to ensure compatibility with the Hamron Steel.

Environmental Conditions

Hamron Steel must only be applied in dry, unexposed conditions that will be free from high humidity and condensation.

Relative humidity: up to 80%

Surface temperature: minimum 5ºC maximum 40ºC

The surface temperature must also be at least 3ºC above dew point.

Optimum drying conditions are at temperatures above 10°C with good air movement.

Application procedure

1. Clean the equipment with suitable solvent , then thoroughly wash with clean water before use.

2. Stir the product to an even consistency using a power mixer. Thinning is not required

3 BRUSH/ROLLER- Apply evenly using a clean, well-loaded brush or roller at up to 300 microns (0.3mm) wet film thickness per coat. Allow at least 4 hours drying at 20°C between coats

4 Clean all equipment with fresh, clean water immediately after use or at least at the end of each working day or shift.

Physical Data

Appearance when dry............. matt

Colour .................................... white

Substrate ................................ primed steel

Volume solids ........................ 70±3%

Shelf life ................................. 12 months

Dry film thickness (μm) .......... 250 400 500 700

Wet film thickness (μm) ......... 360 570 715 1000

Theoretical coverage (m²/l)..... 2.80 1.75 1.40 1.00

Safety Data

This product is not combustible

This product is not a dangerous preparation according to directive 1999/45/EC.

FireProofPaintIreland.com for Cheap Quality Fireproof Fire Retardant and Intumescent Paint in Ireland.
Copyright © 2019 FireProofPaintIreland.com. SydMarketing.com